#Witcher 3 jump in shallow water full#

Geralt can now jump when moving in shallow waters. Jump in Shallow Water does exactly what it says. Oh, and I find that if I have to spin the boat up on plane it works best for me turning clockwise. Jumping in 3rd person in an RPG game is fun. A nicely cupped stainless 4 blade prop may run slower but gets out of the hole with much more authority. With a 3 blade I run a little faster, but need more water (and a lower jack plate) to get out of the hole.

#Witcher 3 jump in shallow water full#

Tabs are always full down for any kind of hole shot.ДЄ lot also depends on the prop you're running. If I want the shallowest hole shot I bump the jack plate up to 3 or 4. If I want the best hole shot I lower the jack plate fully down. Rigged like this, with the motor trimmed slightly down from parallel to the hull, I can usually get a reasonable hole shot with the jack plate raised to 2 on a scale of 0 to 6. On most boats I have rigged, I set the cav plate about 1' above the top of the tunnel (or the keel if no tunnel) with the jack plate full down. You need to experiment and find out what combination of motor trim and jack plate gives you an acceptable hole shot in the least water. Full motor trim down, full jack plate down and full tabs down will give you the best hole shot, but require the most depth of water. If you have your jack plate set properly, chances are you will not be able to get out of the hole with the plate all the way up. Add a third person, I might ask they sit on front bulk head area if we are in smaller take off area or sit wherever in deep open water Add a person, no real change maybe a bit more throttle a little longer. Then in deeper water not where I was fishing give 3/4 throttle instant on plane when alone. Motor is mounted all the way up, jackplate is up 4'(can do 6), tabs in normal running position, motor trimmed down, jack Foreman modified 4 blade. You would be amazed at what adding negative trim will do.

One very important item to only help time to plane but not depth is negative trim spacers. The take off depth won't change in shallower water you just need to know your settings and measure your draft. Ok learn what settings(jack, tabs and people's position) give you the best take off in deeper water. It is the same depth until a certain speed is achieved and boat begins to lean to that side raising motor only slightly since it is center mounted. It only shortens time you may be impacting bottom. Turning hard left may shorten the time it takes to plane. help Prints this message or the help of the given subcommand(s) nhswps The Horizontally Doubly-Periodic Three-Dimensional Non-Hydrostatic Shallow-Water Pseudo-Spectral Method swto3d Converts 2D shallow-water fields to 3D fields needed by nhswps.